Product ID:SHELL TURBO OIL 78
MSDS Date:04/05/1991
FSC:9150
NIIN:01-263-7242
Kit Part:Y
MSDS Number: CHMFM

Emergency Phone: 713-473-9461

Info Phone: 713-241-4819/4141

Cage: 54527

Telephone: 800-231-6950

Cage: 54527

MINERAL OIL,HYDROTREATED (SEVERE), PETROLEUM DISTILLATE,

CAS: 64742-54-7

RTECS: PY8035501

OSHA PEL 5 MG/M3 AS OIL MIST

ACGIH TLV: 5 MG/M3 AS OIL MIST

MINOR ADDITIVE

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE CONTACT: MINIMALLY IRRITATING TO
THE EYES. SKIN CONTACT:CONSIDERED TO BE NO MORE THAN SLIGHTLY
IRRITATING TO THE SKIN.PROLONGED AND REPEATED CONTACT MAY RESULT IN
SKIN DISORDERS SUCH AS DERMATITIS . OIL ACNE OR FOLLICULITIS.
INJECTION OF OIL INTO SKIN MAY RESULT IN LOCAL NECROSIS.
INHALATION: INHALATION OF VAPORS(GENERATED AT HIGH TEMPERATURES
ONLY)OR OIL MIST MAY CAUSE A MILD IRRITATION OFTH E UPPER
RESPIRATORY TRACT. INGESTION: LUBRICATING OILS ARE GENERALLY
CONSIDEREDNO MORE THAN SLIGHTLY TOXIC IF SWALLOWED.
Explanation of Carcinogenicity:THIS PRODUCT AND ITS COMPONENTS ARE NOT
CLASSIFIED AS CARCINOGENS BY IRAC,NTP OR OSHA
Effects of Overexposure:IRRITATION AS NOTED IN HEALTH HAZARDS. NECROSIS
MAY BE EVIDENCED BY DELAYED ONSET OF PAIN AND TISSUE DAMAGE A FEW
HOURS FOLLOWING HIGH PRESSURE INJECTION.
Medical Cond Aggravated by Exposure:PREEXISTING SKIN AND RESPIRATORY
DISORDERS MAY BE AGGRAVATED BY EXPOSURE TO THIS PRODUCT.

First Aid:EYE CONTACT: FLUSH WITH WATER FOR 15 MINUTES WHILE HOLDING
EYELIDS OPEN. GET MEDICAL ATTENTION. SKIN CONTACT: REMOVE
CONTAMINATED CLOTHING AND WIPE EXCESS OFF. WASH WITH SOAP AND WATER
OR A WATERLESS HAND CLEANER FOLLOWED BY SOAP AND WATER.INHALATION:
REMOVE VICTIM TO FRESH AIR AND PROVIDE OXYGEN IF BREATHING IS
DIFFICULT. GET MEDICAL ATTENTION. INGESTION: DO NOT INDUCE
VOMITING. IN GENERAL, IF L ARGE QUANTITIES OF PRODUCT ARE
INGESTED, GET MEDICAL ADVICE.

Flash Point Method:PMCC
Flash Point:=212.8C, 415.F
Extinguishing Media:USE WATER FOG, FOAM, DRY CHEMICAL OR CO2. DO NOT
USE A DIRECT STREAM OF WATER.
Fire Fighting Procedures:DO NOT ENTER CONFINED FIRE SPACE WITHOUT FULL
BUNKER GEAR(HELMET WITH FACE SHIELD, BUNKER COATS,GLOVES AND RUBBER
BOOTS). INCLUDING A POSITIVE PRESSURE NIOSH APPROVED
SELF-CONTAINED BREATHING APPARAT US. COOL FIRE EXPOSED CONTAINERS
WITH WATER.
Unusual Fire/Explosion Hazard:MATERIAL WILL NOT BURN UNLESS PREHEATED.
PRODUCT WILL FLOAT AND CAN BE REIGNITED ON SURFACE OF WATER.

Spill Release Procedures:MAY BURN ALTHOUGH NOT READILY IGNITABLE. LARGE
SPILLS-WEAR RESPIRATOR AND PROTECTIVE CLOTHING AS APPROPRIATE. SHUT
OFF SOURCE OF LEAK IF SAFE TO DO SO. DIKE AND CONTAIN. REMOVE WITH
VACCUM TRUCKS OR PUMP TO STORAGE/SALVAGE VESSELS. SOAK UPRESIDUE
WITH AN ABSORBENT SUCH AS CLAY, SAND OR OTHER SUITABLE MATERIAL.
DISPOSE OF PROPERLY. FLUSH AREA WITH WATER TO REMOVE
RESIDUE.*(OTHER)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE WITH
ADEQUATE VENTILATION. KEEP AWAY FROM OPEN FLAMES AND HIGH
TEMPERATURES.
Other Precautions:SMALL SPILLS-TAKE UP WITH AN ABSORBENT MATERIAL AND
DISPOSE OF PROPERLY.

Respiratory Protection:IF EXPOSURE MAY OR DOES EXCEED OCCUPATIONAL
EXPOSURE LIMITS (SEC.IV), USE NIOSH APPROVED RESPIRATOR TO PREVENT
OVEREXPOSURE. IN ACCORD WITH 29 CFR 1910.134 USE EITHER AN
ATMOSPHERE-SUPPLYING RESPIRATO R OR AN AIR-PRUIFYING RESPIRATOR FOR
ORGANIC VAPORS AND PARTICULATES.
Ventilation:ADEQUATE VENTILATION.
Protective Gloves:CHEMICAL RESISTANT GLOVES(MANFACTURERS INDICATE BEST
PROTECTION NITRLE GLOVES)
Eye Protection:WEAR SAFETY GOGGLES TO AVOID EYE CONTACT.
Other Protective Equipment:WEAR CHEMICAL RESISTANT PROTECTIVE CLOTHING
REQUIRED TO MINIMIZE SKIN CONTACT.LAUNDER CONTAMINATED CLOTHING
BEFORE REUSE. PROPERLY DISPOSE OF CONTAMINATED LEATHER ARTICLES,
SHOES,
Work Hygienic Practices:WASH WITH SOAP AND WATER BEFORE EATING,
DRINKING, SMOKING OR USING TOILET FACILITIES.
Supplemental Safety and Health
KEEP AWAY FROM OPEN FLAVES AND HIGH TEMPERATURES. STORE IN A COOL, DRY
PLACE.

HCC:V6
Melt/Freeze Pt:=-12.2C, 10.F
Spec Gravity:0.8805(H20=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:PALE YELLOW OIL, SLIGHT HYDROCARBON ODOR

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH HEAT, OPEN FLAMES
Hazardous Decomposition Products:THERMAL DECOMPOSITION PRODUCTS ARE
HIGHLY DEPENDENT ON THE COMBUSTION CONDITIONS. A COMPLEX MIXTURE OF
AIRBORNE SOLID,LIQUID, PARTICULATES & GASES WILL EVOLVE WHEN THIS
MATERIAL *SEE BELOW

Waste Disposal Methods:CONSULT LOCAL AUTHORITIES.DISPOSAL MUST BE MADE
IN ACCORDANCE WITH ALL APPLICABLE FEDERAL, STATE AND LOCAL LAWS AND
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.